![]() Note : If you do not successfully log in, leave the password field blank. Enter “ admin ” for the username and “ Senstarcorp ” for the password.In this example, the PC is set to IP address 169.254.242.100 Note : In order for a connection to be established, the computer must be on the same subnet as the controller. Open a web browser and go to: (See Figure 1).Perform a direct connect to the controller via cross-over and a PC/Laptop.Accessing the Network Page of the HID Controller Setting Up the HID VertX/Edge Hardware I. Refer to the chart below for a list of panels and corresponding firmware requirements. Please ensure that you have the correct firmware version for your HID panel. Considerations Prior to Setup This guide will assist you in setting up the HID VertX, Edge, and V2000 controllers in Symphony AC. Please contact Senstar Corporation for questions. The following guide provides steps to configure and initialize the HID VertX or Edge controller panel in the Symphony AC Software.
0 Comments
Leave a Reply. |